Home > News > Content

Reflective Heat Transfer Film Foil Method

Aug 26, 2017

Reflective Heat Transfer Film Foil method

Reflective materials are currently mainly in the field of advertising and traffic safety play an important role, and achieved good results. Such materials in the field of advertising can be used as road and bridge billboards, site enclosures advertising, building construction advertising, light boxes, advertising labels, body advertising, screen advertising. Reflective film in the field of road traffic safety supplies are mainly used in: road signs, anti-collision road cone, temporary construction signs, body reflective signs.

The use of reflective material produced by the ads, with good night visible performance, passing vehicles can clearly see the road contours and pedestrians figure, so that drivers more easily identify obstacles and night pedestrians, like our common traffic police night wear Vest, is made of reflective film material. The use of reflective film material will undoubtedly make driving and the road has a high security, to ensure the safety of drivers and pedestrians at the same time, but also to make traffic more smoothly.

Reflective film storage, cutting and film method precautions

       Reflective film is mainly used for road traffic signs, safety signs, construction signs, advertising signs and other signs, signs and other fields.

One, storage

       Reflective film should be stored in a ventilated, dry, the temperature at 18-24 ℃, relative humidity of 30-50% of the room. The packing box is placed on the pallet or pad, not directly to the ground; its stacking layer does not exceed 5 layers. Reflective film purchased, the request is completed within a year.

Second, cut

       Uncoiling or cutting operation environment: Reflective film should be in the temperature 25 ± 3 ℃, relative humidity of 30-50% of the environment for more than 24 hours before the operation. To ensure cleanliness of workplaces and work tools.

  

       Cutting the reflective film It is advisable for the operator to wear silk or cotton gloves to avoid damaging or contaminating the reflective film surface.

       After the cutting of the reflective film to be placed in a smooth, smooth platform, the platform area is greater than the area of the cutting reflective film. If not used, should be put on plastic bags and tie the bag to prevent moisture. The same shape, the same size of the film must be stacked neatly, control the stacking height of not more than 3cm, do not pressurize any heavy objects.

       Length of more than 3 meters, a larger area of the reflective film should be tightly rolled in the paper tube (paper tube diameter of not less than 100mm), with three tape fixed vertically placed on the plastic bracket, so as to avoid "tunnel" phenomenon. Should be used as soon as possible after the opening of the reflective film. Do not use the reflective film, should be tightened the edge of the membrane rolled to the original paper tube, and fixed with three or more tape, in the paper tube at both ends of the plastic stent, set the plastic bag and then back into the original carton The It can also be worn at the center of the reflector paper tube, placed horizontally on a special shelf or on a plastic tray. Do not throw the unused film directly on the floor or leaning against the wall.

Third, the film method

       Substrate selection: Recommended on the properly treated clean, flat aluminum or stainless steel plate. Not recommended directly attached to the plastic, rubber, wood and other substrate surface. If you need to be attached to non-aluminum or stainless steel plate substrate, the user to determine the application of the reflective film adaptability.

       Substrate processing: just the factory aluminum, stainless steel plate, the surface is very smooth, is not conducive to paste, need to use 400-500 sandpaper in the direction of circular arc grinding. Before the paste must be scrubbed with a degreasing solvent, rinse with water, and dried.